Ihr Webbrowser ist veraltet und wird von uns nicht mehr unterstützt. Bitte verwenden Sie einen aktuellen Browser
anibis logo
anibis alex
anibis alex
de
  1. Startseite
  2. Autos & Autozubehör
  3. Teile & Zubehör
  4. Stossdämpfer
  5. Stossdämpfer Simulatoren zu Corvette C6

Stossdämpfer Simulatoren zu Corvette C6

CHF 95.–

Details

  • Art des Inserats
    Angebot

Beschreibung

Stossdämpfer Simulatoren zu Corvette C6

I N S T A L L A T I O N I N S T R U C T I O N S

109096 REAL TIME DAMPENING (RTD) SIM C6 CORVETTE

This kit is designed to disable DTC codes set from the Real Time Dampening system found in the

2005-up Corvettes fitted with active suspension. Disabling the DTC codes allows for the addition of

aftermarket non-controlled shock absorbers. Using this kit will restore the factory settings to the ECU

module, and prevent the MIL light from illuminating (when the MIL light is on and the code is set, the

car will not be able to exceed 80MPH). The kit consists of four shock plug-ins and four position

sensor plug-ins. Each plug-in module must be inserted into each connector, found at the location of

each wheel. IT SHOULD BE UNDERSTOOD THAT UNDER CERTAIN CIRCUMSTANCES, A YAW

SENSOR CODE WILL BE SET. THE CODE WILL CLEAR ITSELF WITHOUT ADDITIONAL DRIVER INPUT

AND WILL HAVE NO EFFECT ON THE OPERATION OF THESE MODULES.

TO INSTALL

Each wheel location requires (1) two-cavity module and (1) three-cavity module.

Use caution when raising vehicle – suitable equipment must be used.

Remove each wheel and locate the connector for the Position Sensor. Unplug the connector and

replace with the supplied plug-in module (three-cavity). Cable-tie the original connector attached to

the sensor to prevent contact with moving suspension parts. Next, unplug the connector from the

shock absorber solenoid and replace connection with the supplied plug-in module (two-cavity). When

installing the gray 2-cavity connectors, insert connection fully, then wrap supplied cable tie around

each connector to secure side wings. Replacing the shock absorber with conventional shock absorber

will eliminate the pigtail wire connector from the original RTD shock absorber. Replace each wheel

and tighten lug nuts to factory torque specification.

Abholung im Shop möglich.
Oder Paket B-Post - CHF 7.00.


Standort


Inserat teilen


Anbieter

cp-automaten
Registriert seit dem 05.11.2017


Inserat

Letzte Änderung
07.09.2020
Inseratnummer
34421954
Verdächtiges Inserat meldenUnsere Sicherheitstipps

Telefonnummer

+41 793333844